Use Of The External Dc Power Supply - Panasonic AJ-HPX2000 Operating Instructions Manual

Use of the external DC power supply

1
Connect the external DC power supply to the DC IN
socket on the unit.
External DC
power supply
2
Turn "ON" the power switch of the external DC power
supply. (If the power switch is available on the external
DC power supply)
3
Turn ON the POWER switch on the unit.
Inrush current is generated when the power of the unit
is turned on. Insufficient power supply when turning
on the power may cause a malfunction. We recom-
mend using an external DC power supply with double
the capacity of the total power consumption of the unit
and any other connected device that is turned by inter-
locking with the power on of the unit (the viewfinder).
Select the DC cord that is recommended for the exter-
nal DC power supply.
Confirm the pin arrangements of the DC output
connector of the external DC power supply and the
DC IN socket on the unit, and connect the proper
polarities to each other.
If the +12 V power supply is connected to the GND
connector in error, it may cause a fire or failure of
the unit.
4
1
2 3
DC IN Socket
100
Preparation ：Power Supply
DC IN Socket
Pin No. Signal
1 GND
2, 3 —
4 +12V
Notes
If both the battery pack and the external DC power
supply are connected, the electric power is supplied
from the external DC power supply. While the
external DC power supply is used, the battery can
be mounted and removed on/from the unit.
When the external DC power supply is used, ensure
that the power switch of the external DC power supply
is turned on first and then the POWER switch on the
unit is turned on. In the case of the reverse operation,
a malfunction may occur on the unit since the output
voltage of the external DC power supply is raised
slowly.