Power Supply And Accessory Mounting Section - Panasonic AJ-HPX2000 Operating Instructions Manual

Parts and their Functions

Power Supply and Accessory Mounting Section

1
1.
POWER switch
Used to turn on/off the power.
2.
Battery mount
A battery pack from Anton/Bauer is mounted here.
3.
DC IN (external power input) socket (XLR, 4P)
camera-recorder is connected to an external DC
power supply.
4.
BREAKER switch
When an excessive amount of current is fed through
the camera-recorder, due to any abnormal event, the
breaker automatically turns off the power in order to
protect the device.
After the interior of the camera-recorder has been
checked and/or repaired, this button must be
depressed. If there is no unusual reaction, the unit can
be powered-up.
5.
GPS connector
This connects the optional GPS unit AJ-GPS910G.
6.
Shoulder strap fittings
The shoulder strap is attached here.
7.
Light shoe
A video light or similar accessory can be attached
here.
8.
Lens mount (bayonet 2/3-type)
The lens is attached here.
9.
Lens lever
Lower this lever to lock the lens to the lens mount.
14
Parts and their Functions ： Power Supply and Accessory Mounting Section
6
2
4 3
15
10.
Lens mount cap
To remove the cap, raise the 9. lens lever.
When the lens is not mounted, replace the cap.
11.
Light cable clamp
Secures the light cable.
12.
Lens cable/microphone cable clamp
This clamp secures the lens and microphone cables.
13.
Tripod mount
When you want to mount camera-recorder on a tripod,
the optional tripod adapter (SHAN-TM700) is attached
here.
14.
LENS jack (12-pin)
The lens connection cord is connected here. For a
detailed description of your lens, see the relevant
manufacturer's instruction manual.
15.
DC OUT (DC power supply) output socket
This output socket is designed for 12-VDC. It provides
a maximum current of 1.5 A.
Connect an external switch to this socket to control
REC starts and stops or an LED for use as a tally
lamp. For more information, see [ Connection of the
external switch ] (page 108).
5 7 6
11
12 13
14
9
8
10