Recording Review Function - Panasonic AJ-HPX2000 Operating Instructions Manual

Recording Review Function

When recording is paused, pressing the RET button
automatically locates the last two seconds of video just
recorded, and the viewfinder provides video playback.
After playback, the camera-recorder is again ready to start
recording.
The picture location/playback duration can be increased to
up to 10 seconds by continuously pressing the RET button.
For short clips, however, when the start of a clip is located,
continuously pressing the RET button does not play back
any clips before that clip.
The function of the RET button may be assigned to a
desired user button by using one of the menu options
USER MAIN SW, USER1 SW or USER2 SW. These
options can be found in the <USER SW> screen on the
CAM OPERATION page.
When recording is paused, pressing the PLAY/PAUSE
button plays back the last recorded clip, from the
beginning. After completion of playback, the camera-
recorder enters the stopped state.
Recording starts
Recorded clip
The PLAY button plays back
the clip from the beginning.
Notes
Set the menu option RET SW (found on the SW MODE
page for CAM OPERATION) to R. REVIEW.
When the OUTPUT SEL switch on the side panel is
positioned at [MEM], the video for REC REVIEW is
output from the video output connectors (VIDEO OUT
and MON OUT connectors), and also to the viewfinder.
Note that when a backup device is connected to back up
the video the pictures for REC REVIEW are backed up.
Recording pauses
2-10 Seconds
The RET button
puts the camera-
recorder into REC
REVIEW mode.
Recording and Playback ：Recording Review Function
39