Panasonic AJ-HPX2000 Operating Instructions Manual page 86

6
Turn the JOG dial button until a desired character
appears.
The characters that appear are switched in the
following order:
Space:
Alphabetical characters: A to Z
Numerals:
Symbols:
7
Press the JOG dial button to accept a desired
character.
8
Turn the JOG dial button to move the cursor to the
next digit (clockwise), and repeat Steps
characters (up to eight characters).
To write data on a selected file
9
When the title is set, turn the JOG dial button to move
the cursor to [:].
< SD CARD READ/WRITE >
R.SELECT
READ
W.SELECT
WRITE
CARD CONFIG
TITLE READ
;
TITLE:
1: ********
2: ********
3: ********
4: ********
10
Press the JOG dial button to return the cursor to the
option [TITLE:].
11
Turn the JOG dial button to move the cursor to the
option [WRITE].
12
Press the JOG dial button to display the following
message:
WRITE?
YES
#
NO
TITLE:
86 Adjustments and Settings for Recording : Handling data
0 to 9
', >, <, /, -
6
-
:1
:1
5: ********
6: ********
7: ********
8: ********
The data will not be written if any of the following
messages appears when the JOG dial button is pressed:
Error message
WRITE NG
NO CARD
(No SD memory card inserted.)
WRITE NG
FORMAT ERROR
(SD memory card not properly
formatted.)
WRITE NG
ERROR
(SD memory card not writable.)
WRITE NG
WRITE PROTECT
(SD memory card write-
protected.)
WRITE NG
CANNOT ACCCESS
7
to set
(SD memory card not
accessible.)
WRITENG
CARD FULL
(SD memory card has no free
space.)
13
Turn the JOG dial button to move the cursor to YES.
Then, press the dial button.
When the data has been written, the following
message appears:
WRITE OK
14
To exit the menu, press the MENU button.
The settings menu disappears and the status of the
unit is indicated at the top and bottom of the
viewfinder screen.
Notes
The SD CARD R/W SELECT screen can be used to
select the type of the menu to be written on the SD
memory card.
It is possible to overwrite the setup file on the unit with a
setup file from another device. Note that if the file is
overwritten, the original setup file from the other device
will be lost.
We recommend managing the respective SD memory
cards on the respective devices independently.
Remedy
Insert an SD memory card.
The card has not been
formatted using the unit.
Replace the card.
The card may be defective.
Replace the card.
Remove the card and disable
the protect.
Example: The SD memory card
is not accessible because it is
being played back.
After the operation in process,
format the card.
The card is not writable
because it has no free space.
Delete unwanted files or
replace the card with a new
one.