Panasonic AJ-HPX2000 Operating Instructions Manual page 85

4
To format the SD memory card, turn the JOG dial
button to move the cursor to YES. Then, press the dial
button.
When the SD memory card has been formatted, the
following message appears:
CONFIG OK
The card will not be formatted if the following message
appears when the JOG dial button is pressed:
Error message
CONFIG NG
NO CARD
(No SD memory card inserted.)
CONFIG NG
ERROR
(SD memory card cannot be
formatted.)
CONFIG NG
WRITE PROTECT
(SD memory card is write-
protected.)
CONFIG NG
CANNOT ACCCESS
(SD memory card not
accessible).
5
To exit the menu, press the MENU button.
The settings menu disappears and the status of the
unit is indicated at the top and bottom of the
viewfinder screen.
Note
If an SD memory card is inserted or removed with the
<SD CARD READ/WRITE> screen open, the data
title cannot be edited.
Move the cursor to the option TITLE READ and press
the JOG dial button.
Edit the data title.
Remedy
Insert an SD memory card.
The card may be defective.
Replace the card.
Remove the card and cancel
the protect.
Example: The SD memory card
is not accessible because it is
being played back.
After the operation in process,
format the card.
To write set data on an SD memory card
1
Navigate the menu to the <SD CARD READ/WRITE>
screen.
To select a file number
2
Turn the JOG dial button to move the cursor to the
option [W. SELECT]. Then, press the dial button.
< SD CARD READ/WRITE >
R.SELECT :1
READ
#
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
3
Turn the JOG dial button to select a desired number
(1 - 8). Then, press the dial button.
To give the selected file a title
4
Turn the JOG dial button to move the cursor to the
option [TITLE:].
< SD CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
#
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
5
Press the JOG dial button. This moves the cursor to
the entry area, putting the unit in entry mode.
< SD CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
;
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
Adjustments and Settings for Recording : Handling data
85