Power Saving Setting - Fujitsu fi-5950 Operator's Manual

8.2 Power saving setting

When not using this scanner for a certain time, it will enter automatically the power saving mode.
Configure the Power saving mode as follows:
1. Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page 175
2. Select [Device Setting] from left side list in the window.
3. Use the slide control bar to set the waiting time before entering the power
saving mode.
Setting range 15 - 55 minutes. (Set in steps of 5 minutes)
HINT
190

8.2 Power saving setting

When you select the [Power off after a certain period of time] check box, the
scanner will turn itself off automatically if it is turned on and left unused for
the set time. The time until power-off can be selected from 1/2/4/8 hours.
.