Thin Paper Mode - Fujitsu fi-5950 Operator's Manual

8.16 Thin Paper Mode

If nonstandard thin paper cannot be fed and scanned smoothly, use this mode.
In this mode, sheets of paper are fed at a slower speed so that thin paper can be fed and scanned properly.
Follow the steps below to switch to the Thin Mode.
1. Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page 175
2. Select [Device Setting 2] from left side list in the window, and select [Thin
Paper Mode] from its lower level.
3. Select one of the following option.
Disable

Thin paper mode

Super-thin paper
mode
ATTENTION
: For the document described in the Document specification.
: For the thin document than described in the Document specification.
: For very thin document rather than the Thin paper above.
In Thin Paper Mode, the document is scanned at a lower speed, and thus it
takes longer.
This mode should be used only for thin paper. Set the setting to "Disable"
while you use paper of standard thickness.
About the paper thickness, refer to
.
"7.2 Document Quality" on page
8.16 Thin Paper Mode
8
161.
211