Temporary Errors - Fujitsu fi-5950 Operator's Manual

■ Temporary Errors

[J] or [U] and a number will be displayed alternately.
(When pushing the [Scan] or [Send to] button, the error indication on the function number display will dis-
appear and the scanner goes into the ready status.)
Display
J0 The paper feeding stopped to protect jammed
paper from damage.
U1 A paper jam occurred.
U2 A Multifeed occurred.
U4 The ADF or the Pre-Imprinter cover is opened.
U6
The print cartridge of the imprinter (sold sepa-
rately) is not set.
U8
One of the following error occurred:
1. Document sensors are dirty.
2. The stacker is full.
3. The Brake roller or Separator rollers are not
installed properly.
(*1) If you press the [Send to] button before the error message is displayed on the PC screen, multifed doc-
uments are not ejected.
Meaning
6.2 Error messages of the Operator panel
Solution
1. Remove the jammed document. Refer to
Clearing Document Jams" on page
2. Confirm if the document conditions are appropri-
ate for scanning with the ADF. (Refer to
Document Quality" on page
When pushing the [Send to] on the Operator panel,
the multi fed papers will be ejected.(*1)
Close the ADF cover or Pre-Imprinter cover cor-
rectly.
This error occurs only when the imprinter option
(sold separately) is used.
Refer to the "fi-590PRF/fi-590PRB Imprinter
Operator Guide" for further details.
1. Clean the document sensors.
For details, refer to "4.5 Cleaning the Transport
path and the sensors" on page
2. Verify that the number of sheets ejected to the
stacker is below stacker's capacity, and that the
Pick roller is not set for manual feeding.
3. Verify that the both rollers are installed properly.
For details, refer to "5.5 Replacing the Separator
Rollers" on page 130 and
Brake Roller" on page 133.
"6.1
136.
"7.2
161)
116.
"5.6 Replacing the
139
6