Bridge Mode - TRENDnet TEW-730APO User Manual

TRENDnet User's Guide
o 802.11b/g mixed mode (2.4GHz) - This wireless mode works in the 2.4GHz
frequency range and will allow both wireless b and wireless g client to
connect and access point, at 54Mbps for wireless g and share access at the
same time. Although the wireless b/g operates in the 2.4GHz frequency, it
will allow the use of other 2.4GHz client devices (Wireless n/g @ 54Mbps) to
connect and access at the same time.
o 802.11b/g/n mixed mode (2.4GHz) - This wireless mode works in the 2.4GHz
frequency range and will only allow the use of wireless g client devices to
connect and access point, 54Mbps for wireless g and up to 300Mbps* for
wireless n and share access at the same time. Although the wireless b/g/n
operates in the same 2.4GHz frequency, it will allow the use of other 2.4GHz
client devices (Wireless b/g/n) to connect and access at the same time.
 802.11 Mode: Four levels are available: 5MHz, 10MHz, 20MHz and 40MHz. The
last one can enhance data throughput, but it takes more bandwidth, thus it might
cause potential interference.
 Data Rate: Usually "Auto" is preferred. Under this rate, the IEEE 802.11b/g/n
Wireless CPE will automatically select the highest available rate to transmit. In
some cases, however, like where there is no great demand for speed, you can
have a relatively-low transmit rate for compromise of a long distance.
 Output power: Specify the signal transmission power. The higher the output
power is, the wider the signal can cover, but the power consumption will be
greater accordingly.
 Enable MAC Clone: Available only under wireless client mode, it hides the MAC
address of the AP while displays the one of associated wireless client or the MAC
address designated manually.
Site Survey
The following section outlines how to utilize the site survey option in Wireless Client
mode.
1. Log into the management page (see
2. Click on Wireless button and click on Basic Settings.
3. Select Wireless Client in the Operation Mode pull down menu and click Apply.
4. Click Site Survey button.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access the management page" on page 27).
5. The access point will automatically scan for available access points.
6. Select the access point or wireless network you want to connect.
7. Click either Select AP , Select SSID or Scan option.
 Select AP: Configures the access point based on the selected AP's SSID and MAC
address
 Select SSID: Configures the access point based on the selected AP's SSID only
 Scan: Scans for available wireless networks.
8. Click Apply when you have selected the wireless network you want to connect with.
9. If your wireless network is configured with wireless security, click Profile Settings
 Security Settings: Select and configure the wireless security of your wireless
network. Click Apply to save settings. Please refer to Wireless Encryption Type
section on page30.

Bridge Mode

TEW-730APO
15