Ap Repeater Mode - TRENDnet TEW-730APO User Manual

TRENDnet User's Guide
wireless n and share access at the same time. Although the wireless b/g/n
operates in the same 2.4GHz frequency, it will allow the use of other 2.4GHz
client devices (Wireless b/g/n) to connect and access at the same time.
 Frequency (Channel): To manually set the channel on which the router will
broadcast, uncheck Auto Channel, then click the drop-down list and select the
desired Channel for wireless communication. The goal is to select the Channel
that is least used by neighboring wireless networks.
 Extension channel: When 20/40 channel bandwidth has been chosen, you should
select extension channel to get higher throughput.
 Channel Mode: Four levels are available: 5MHz, 10MHz, 20MHz and 40MHz. The
last one can enhance data throughput, but it takes more bandwidth, thus it might
cause potential interference.
 Data Rate: Usually "Auto" is preferred. Under this rate, the IEEE 802.11b/g/n
Wireless CPE will automatically select the highest available rate to transmit. In
some cases, however, like where there is no great demand for speed, you can
have a relatively-low transmit rate for compromise of a long distance.
 Maximum Output power: Specify the signal transmission power. The higher the
output power is, the wider the signal can cover, but the power consumption will
be greater accordingly.
Wireless >WDS Setting
This section outlines the available management options under the WDS Settings of the
Wireless button. WDS Settings is available only under Bridge and AP Repeater Mode.
 WDS Separation: Enable separates all configured WDS AP to communicate with
each other.
 Remote AP: Enter the MAC address of the access point you want to WDS with.
© Copyright 2015 TRENDnet. All Rights Reserved.
Note: You must enter the MAC address of every access point in the WDS
network. Each wireless setting (SSID, channel, wireless encryption) must match
on each access point in the WDS network.

AP Repeater Mode

AP Repeater mode allows the access point to repeat a wireless signal of an existing
wireless network. This section outlines available management options when the device
System Setting is set to Bridge and the wireless Operation Mode is set to AP Repeater.
Click Apply to save any changes.
Note: The access point's wireless settings must be configured with the exact wireless
settings as the repeating signal (Network name, channel, wireless security, etc.)
 Disable Wireless LAN Interface:
TEW-730APO
17