Port Filtering; Mac Filtering; Port Forwarding - TRENDnet TEW-730APO User Manual

TRENDnet User's Guide
 Enable Source IP Filtering: Check this option to enable source IP filtering
 Filter Type: Select IP Filter in the pull down menu
 Protocol: Select the protocol you would like to filter.
 Direction: Select the direction of the packets to filter.
 IP Address: Enter the IP address or range of IP address to assign.
 Comment: Enter any notes you would like to add to distinguish the rule.

Port Filtering

The Port filtering gives you the ability to restrict the computers in LAN from accessing
certain websites in WAN according to specified IP addresses. Please note that this
feature is only available when access point System Mode is set to Router.
1. Log into the management page (see
2. Click on Firewall Settings.
 Enable Source IP Filtering: Check this option to enable source Port filtering
 Filter Type: Select Port Filter in the pull down menu
 Protocol: Select the protocol you would like to filter.
 Direction: Select the direction of the packets to filter.
 Port: Enter the IP address or range of IP address to assign.
 Comment: Enter any notes you would like to add to distinguish the rule.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access the management page" on page 9).

MAC Filtering

The MAC filtering enables you to restrict certain MAC address to have access to your
network. Please note that this feature is only available when access point System Mode
is set to Router.
1. Log into the management page (see
2. Click on Firewall Settings.
 Enable Source IP Filtering: Check this option to enable source IP filtering
 Filter Type: Select MAC Filter in the pull down menu
 Protocol: Select the protocol you would like to filter.
 Direction: Select the direction of the packets to filter.
 MAC Address: Enter the IP address or range of IP address to assign.
 Comment: Enter any notes you would like to add to distinguish the rule.

Port Forwarding

The destination port filtering enables you to restrict certain ports of data packets from
your local network to Internet through the access point. Use of such filters can be
helpful in securing or restricting your local network. Please note that this feature is only
available when access point System Mode is set to Router.
1. Log into the management page (see
2. Click on Firewall Settings, and click on Port Forwarding. Click Apply to save settings.
TEW-730APO
"Access the management page" on page 9).
"Access the management page" on page 9).
26