Change Your Login Password; Access Control; Ip Filtering - TRENDnet TEW-730APO User Manual

TRENDnet User's Guide
 A-MPDU/A-MSDU aggregation: The data rate of your AP except wireless client
mode could be enhanced greatly with this option enabled; however, if your
wireless clients don't support A-MPDU/A-MSDU aggregation, it is not
recommended to enable it.
 Short GI: Under 802.11n mode, enable it to obtain better data rate if there is no
negative compatibility issue.
 RTS Threshold: The IEEE 802.11b/g/n Wireless CPE sends RTS (Request to Send)
frames to certain receiving station and negotiates the sending of a data frame.
After receiving an RTS, that STA responds with a CTS (Clear to Send) frame to
acknowledge the right to start transmission. The setting range is 0 to 2346 in
byte. Setting it too low may result in poor network performance. Leave it at its
default of 2346 is recommended.
 Fragment Threshold: Specify the maximum size in byte for a packet before data is
fragmented into multiple packets. Setting it too low may result in poor network
performance. Leave it at its default of 2346 is recommended.
 Beacon Interval: Specify the frequency interval to broadcast packets. Enter a
value between 20 and 1024.
 DTIM Interval: DTIM, which stands for Delivery Traffic Indication Message, is
contained in the data packets. It is for enhancing the wireless transmission
efficiency. The default is set to 1. Enter a value between 1 and 255.
© Copyright 2015 TRENDnet. All Rights Reserved.

Change your login password

1. Log into the management page (see
2. Click on Management, and click on Password Settings. Click Apply to save changes.
 Current Password: Enter the current password of the access point.
 New Password: Enter the new password
 Confirm Password: Re-enter the new password to confirm.
Note: If you change the login password, you will need to access the management page
using the new password instead of the default password "admin".

Access Control

IP Filtering

IP Filtering gives users the ability to restrict certain types of data packets from your local
network to the access point based on assigned IP address. Use of such filters can be
helpful in securing or restricting your local network. Please note that this feature is only
available when access point System Mode is set to Router.
1. Log into the management page (see
2. Click on Firewall Filtering.
TEW-730APO
"Access the management page" on page 9).
"Access the management page" on page 9).
25