Upgrade Firmware - TRENDnet TEW-730APO User Manual

TRENDnet User's Guide
 Secure: Select this mode to activate SSH, HTTPS, and WISE
 Customized: Select this mode to manually choose the management modes
4. If SNMP is one of the management tools you have selected. You will need to complete
the below settings.
 Protocol Version: Select from the pull down menu the SNMP version to use.
 Server Port: Enter the your SNMP server port
 Get Community: Enter the password for the incoming Get and GetNext requests
from the management station
 Set Community: Specify the password for the incoming Set requests from the
management station.
 Trap Destination: Specify the IP address of the station to send the SNMP traps to.
 Trap Community: Specify the password sent with each trap to the manager.
To use SNMP V3, click the option "Configure SNMPv3 User Profile" to display the
configuration settings.
© Copyright 2015 TRENDnet. All Rights Reserved.
 User Name: Specify a user name for the SNMPv3 administrator or user. Only the
SNMP commands carrying this user name are allowed to access the access point
 Password: Specify a password for the SNMPv3 administrator or user. Only the
SNMP commands carrying this password are allowed to access the access point
 Confirm Password: Input password again to confirm
 Access Type: Select "Read Only" or "Read and Write" accordingly.
 Authentication Protocol: Select an authentication algorithm. SHA authentication
is stronger than MD5 but is slower.
 Privacy Protocol: Specify the encryption method for SNMP communication. None
and DES are available.
o None: No encryption is applied.
o DES: Data Encryption Standard, it applies a 58-bit key to each 64-bit block of
data.

Upgrade Firmware

You may have added many customized settings to your router and in the case that you
need to reset your router to default, all your customized settings would be lost and
would require you to manually reconfigure all of your router settings instead of simply
restoring from a backed up router configuration file.
1. Log into the management page (see
TEW-730APO
"Access the management page" on page 9).
29