Wireless Client Mode - TRENDnet TEW-730APO User Manual

TRENDnet User's Guide
o Disabled turns off the ability for wireless devices to find your network. It is
still possible for wireless devices to be configured to connect to your wireless
network.
 Wireless Separation:
o Enabled separates all wireless clients connected to this SSID, clients cannot
communicate with each other.
o Disabled allows all wireless clients connect to this SSID to communicate with
each other
 WMM: Wi-Fi Multimedia is a Quality of Service (QoS) feature which prioritizes
audio and video data packets. This feature requires the wireless device to also
support WMM. Click Enabled (recommended) or Disabled to turn this feature on
or off on your router.
 Max. Station Num.: Select this option to limit the amount of clients who can
connect to this SSID.
o Enter the amount of clients you would like to limit.

Wireless Client Mode

This section outlines available management options when the device System Setting is
set to Bridge and the wireless Operation Mode is set to Wireless Client. Click Apply to
save any changes.
© Copyright 2015 TRENDnet. All Rights Reserved.
 Disable Wireless LAN Interface:
o Check/Off: turns off wireless networking on your router.
o Unchecked/On: turns on the wireless networking on your router (by default
it is enabled).
Note: It is recommended to leave the wireless setting to On unless you do not plan
on connecting any wireless computers or devices to your network.
 Operation Mode: Select the mode you want the access point to operate in.
o AP: refer to page11 for additional information.
o
Wireless Client: refer to page13 for additional information
o Bridge: refer to page 16 for additional information
o
AP Repeater: refer to page18 for additional information to operate the
device as an access point.
 Site Survey: Click to scan and select available wireless networks.
 Wireless Network Name (SSID): This acronym stands for Service Set Identifier
and is the name of your wireless network. You can manually enter the wireless
network you want to connect to or click "Site Survey" option to scan for available
wireless networks around you. Ple
 Lock AP MAC: Enter the MAC address of the access point you are connected.
 802.11 Mode: If all of the wireless devices you want to connect with this Access
Point can connect in the same transmission mode, you can improve performance
slightly by choosing the appropriate mode. If you have some devices that use a
different transmission mode, choose the appropriate mode.
TEW-730APO
14