L2 Features > Vlan > Auto Surveillance Vlan > Mac Settings And Surveillance Device - D-Link DXS-1100 series User Manual

4 Configuration
Figure 4.78 – L2 Features > VLAN > Auto Surveillance VLAN> Auto Surveillance Properties
The fields that can be configured are described below:
Surveillance VLAN: Enable or disable the surveillance VLAN state
Surveillance VLAN ID: Enter the surveillance VLAN ID. The range is from 2 to 4094.
Surveillance VLAN CoS: Select the priority of the surveillance VLAN from 0 to 7.
Aging Time: Enter the aging time of surveillance VLAN. The range is from 1 to 65535 minutes. The default
value is 720 minutes. The aging time is used to remove a port from surveillance VLAN if the port is an
automatic surveillance VLAN member. When the last surveillance device stops sending traffic and the MAC
address of this surveillance device is aged out, the surveillance VLAN aging timer will be started. The port
will be removed from the surveillance VLAN after expiration of surveillance VLAN aging timer. If the
surveillance traffic resumes during the aging time, the aging timer will be reset and stop.
From Port / To Port: Select the appropriate port range used for the configuration here.
State: Enable or disable the state of the port.
Click Apply to accept the changes made for each individual section.
L2 Features > VLAN > Auto Surveillance VLAN > MAC Settings and Surveillance Device
This window is used to configure the user-defined surveillance device OUI and display the surveillance
VLAN information.
D-Link 10 Gigabit Ethernet Switch User Manual
5 7
5 7