Table of Contents
Advertisement
2 Hardware Installation
2
Hardware Installation
This chapter provides unpacking and installation information for the Switch.
Step 1: Unpacking
Open the shipping carton and carefully unpack its contents. Please consult the packing list located in the
User Manual to make sure all items are present and undamaged.
One D-Link 10 Gigabit Ethernet Switch
One AC power cord
One set of Power cord retainer
Four rubber feet
Screws and two mounting brackets
One Multi-lingual Getting Started Guide
One CD with Web UI Reference Guide, Getting Started Guide, and D-Link Network Assistant User
Guide.
If any item is found missing or damaged, please contact the local reseller for replacement.
Step 2: Switch Installation
For safe switch installation and operation, it is recommended that you:
Visually inspect the power cord to see that it is secured fully to the AC power connector.
Make sure that there is proper heat dissipation and adequate ventilation around the switch.
Do not place heavy objects on the switch.
Desktop or Shelf Installation
When installing the switch on a desktop or shelf, the rubber feet included with the device must be attached
on the bottom at each corner of the device's base. Allow enough ventilation space between the device and
the objects around it.
Rack Installation
The switch can be mounted in an EIA standard size 19-inch rack, which can be placed in a wiring closet with
other equipment. To install, attach the mounting brackets to the switch's side panels (one on each side) and
secure them with the screws provided (please note that these brackets are not designed for palm size
switches).
Figure 2.1 – Attach the adhesive rubber pads to the bottom
8
8
D-Link 10 Gigabit Ethernet Switch User Manual
Hide quick links:
Advertisement
Table of Contents
