System > Port Configuration > Port Settings - D-Link DXS-1100 series User Manual

4 Configuration
The fields that can be configured are described below:
Fan Trap: Enable or disable the fan trap state for warning fan event (fan failed or fan recover).
Thermal: Select the thermal sensor ID.
High Threshold: Enter the high threshold value of the warning temperature setting. The range is from -100
to 200 Celsius degree. Tick Default to return to the default value. The default value is 79.
Low Threshold: Enter the low threshold value of the warning temperature setting. The range is from -100 to
200 Celsius degree. Tick Default to return to the default value. The default value is 11.
Click Apply to accept the changes made for each individual section.
System > Port Configuration > Port Settings
This window is used to view and configure the Switch's port settings.
The fields that can be configured are described below:
From Port / To Port: Select the appropriate port range used for the configuration here.
Medium Type: If configuring the Combo ports, this defines the type of transport medium to be used.
State: Select this option to enable or disable the physical port here.
MDIX: Select the Medium Dependent Interface Crossover (MDIX) option here. This is only available when
the copper port is selected. Options to choose from are Auto, Normal, and Cross.
Auto - Select this option for auto-sensing of the optimal type of cabling.
Normal - Select this option for normal cabling. If this option is selected, the port is in the MDIX mode
and can be connected to a PC's NIC using a straight-through cable or a port (in the MDIX mode) on
another switch through a cross-over cable.
Cross - Select this option for cross cabling. If this option is selected, the port is in the MDI mode and
can be connected to a port (in the MDIX mode) on another switch through a straight cable.
Figure 4.30 – System > Port Configuration > Port Settings
3 0
3 0
D-Link 10 Gigabit Ethernet Switch User Manual