Hardware Description And Installation; Led Indicators - D-Link DSL-224 User Manual

Section 2 – Installation

LED Indicators

Note:
The figures in this document are for reference only.
The following table describes the LEDs of the device.
LED Color
Green
Power
Red
LAN Green
WLAN Green
Green
WPS
D-Link DSL-224 User Manual

Hardware Description and Installation

Status
Off The power is off.
On The initialization of the system is complete.
On The device is initiating.
Blinking The firmware is upgrading.
Off The Ethernet interface is not properly connected.
Blinking The Ethernet interface is properly connected and data is being transmitted.
On The Ethernet interface is properly connected, but no data is being transmitted.
Blinking The WLAN function is enabled and data is being transmitted over the WLAN.
On The WLAN function is enabled, but no data is being transmitted over the WLAN.
Off The WLAN function is disabled.
Blinking WPS is successfully triggered.
Solid on for 5
seconds and Connection is successfully established between the router and the client through WPS.
then turns off
Figure 1 Front panel
Description
9