Removing And Installing The Appliance Door - Thermador MES301HS Use And Care Manual

Starting Decalcify Mode
The oven cavity must be cooled down completely.
Touch and hold ON/OFF until the appliance turns on.
1.
Touch DECALCIFY to select Decalcify mode.
2.
Touch START/STOP. Decalcify mode starts. The light
3.
in the oven remains off.
Cleaning Cycle 1
A beep sounds after approximately 30 minutes. The
(fill water tank) symbol appears.
Wash out the water tank thoroughly, fill it with water
1.
and slide it back in. the
symbol appears.
Use the cleaning sponge provided to remove any
2.
water remaining in the evaporator dish.
Touch START/STOP. The appliance starts the cleaning
3.
process.
Cleaning Cycle 2
After a short time, the
<
time.
Thoroughly wash out the cleaning sponge.
1.
Use the cleaning sponge to remove any water
2.
remaining in the evaporator dish.
Touch START/STOP. The appliance starts the cleaning
3.
process. After Decalcify mode is complete,
appears.
Touch and hold ON/OFF.
4.
Removing Residual Water
Use the cleaning sponge to remove any water remaining
in the evaporator dish. Wipe down the oven using the
cleaning sponge and dry afterwards using a soft cloth.
Canceling Decalcify Mode
Touch and hold ON/OFF. Decalcify mode stops.
1.
The appliance must be cleaned twice after Decalcify
mode is canceled to ensure that no descaling solution
remains inside.
Touch ON/OFF. The
9
2.
Now follow the same steps as under Cleaning Cycle 1
described above.
Descaling Only the Evaporator Dish
You can also use Decalcify mode to descale only the
evaporator dish in the oven cavity without descaling the
entire appliance.
The only difference in this procedure is as follows:
Mix 1 cups of water and 2 teaspoons powder
Y
1.
descaler to produce a descaler solution.
Fill the evaporator dish completely with the descaling
2.
solution.
Fill the water tank with water only.
3.
Start Decalcify mode as described.
4.
You can also descale the evaporator dish manually.
(empty evaporator dish)
<
symbol appears for the second
<
symbol appears.
Removing and Installing
the Appliance Door
The appliance door can be removed for easy cleaning.
CAUTION
9
WHEN REMOVING THE OVEN DOOR:
Make sure oven is cool and power to the oven
▯
has been turned off before removing the door.
9
Failure to do so could result in electrical shock or
burns.
The oven door is heavy and parts of it are fragile.
▯
Use both hands to remove the oven door. The
door front includes glass components. Handle
carefully to avoid breakage.
Grasp only the sides of the oven door. Do not
▯
grasp the handle as it may swing in your hand
and cause damage or injury.
Failure to grasp the oven door firmly and properly
▯
could result in personal injury or product damage.
To avoid injury from hinge bracket snapping
▯
closed, be sure that both locking levers are
securely in place before removing the door. Also,
do not force the oven door open or closed - the
hinge could be damaged and injury could result.
If the door is removed without turning both
▯
retainers until thex stop, the hinge can snap back.
Do not reach into the hinge area. Call customer
service.
Do not lay the removed door on sharp or pointed
▯
objects as this could break the glass. Lay the
door on a flat, smooth surface, positioned so that
the door cannot fall over.
Removing the Appliance Door
Open the door all the way.
1.
Lay the two stop levers on the right and left down flat
2.
(picture A).
Position the door at an angle. Use both hands to grasp
3.
the left and right sides of the door. Close the door a
little more and then remove it (picture B).
$
%
25