Thermador MES301HS Use And Care Manual page 16

If operation has not yet started, touch START/STOP.
3.
The running Cook Time is visible in the display.
Note: When using Steam mode, the Cook Time starts
after the appliance is preheated.
After the Cook Time runs out
A beep sounds. The appliance stops heating. Touch
TIMER/CLOCK to stop the signal early.
CAUTION
9
Hot steam can escape when opening the oven
door.
Open the oven door.and use potholders to carefully
remove ovenware. Touch and hold ON/OFF until the
appliance turns off.
Changing the Cook Time
Touch TIMER/CLOCK repeatedly until the arrow appears
after the Cook Time symbol. Use the settings dial to
xO
change the Cook Time. The changed Cook Time starts.
Checking the Time Settings
Use TIMER/CLOCK to check all settings.
Changing the End Time
You can change the time when the food will be done.
The appliance starts automatically and turns off at the
preferred End Time.
CAUTION
9
To maintain food safety, do not leave food in the
oven for more than one hour before or after
cooking.
Note: Some programs do not allow the End Time to be
changed.
The time required for preheating when using Steam must
be considered when setting the Cook Time. The set End
Time can be delayed to make up fo the time required for
preheating.
Delaying the End Time
The example is shown in the illustrations:
It is 9:30 a.m. The food takes 45 minutes to cook, but
should not be ready until 12:45 p.m.
Requirements:
The set mode has not started.
▯
A Cook Time has been set.
▯
16
Touch TIMER/CLOCK repeatedly until the arrow
1.
appears after the End Time symbol
The bars in the display indicate that the End Time has
not been changed.
Use the settings dial to set the End Time to a later
2.
time.
Touch START/STOP to confirm.
3.
The setting is accepted. The appliance is in delayed
mode. The End Time
Operation starts automatically at the correct time. In the
example, operation starts at 12:00 p.m. The running
Cook Time then appears in the display.
xO
Adjusting the End Time
The End Time can be adjusted as long as the appliance
is in delayed mode. To do this, use TIMER/CLOCK to
switch to End Time
yO
adjust the End Time.
Canceling the End Time
The End Time can be canceled as long as the appliance
is in delayed mode. To do this, use TIMER/CLOCK to
switch to End Time
yO
left until - -:- - appears. Cook Time starts immediately.
After the Cook Time runs out
A beep sounds. The appliance stops heating. Touch
TIMER/CLOCK to stop the signal early.
CAUTION
9
Hot steam can escape when opening the oven
door.
Open the oven door.and use potholders to carefully
remove ovenware. Touch and hold ON/OFF until the
appliance turns off.
Setting the Clock
The appliance must be off in order to set or change the
clock.
After a Power Outage
After a power outage, four zeros flash in the display.
Use the settings dial to set the current time.
1.
Touch TIMER/CLOCK. The clock setting is accepted.
2.
.
yO
is displayed.
yO
and use the settings dial to
and turn the settings dial to the