Fill Water Tank - Thermador MES301HS Use And Care Manual

Adjusting the Water Hardness Level
Descale the appliance using Decalcify mode at regular
intervals. This can prevent damage to the appliance.
The appliance automatically informs you when descaling
is required. The factory setting is water hardness level II.
Change the setting if your water is softer or harder.
Checking water hardness
Check the water hardness using the test strips provided
or ask your water utility company.
Softened water
Descaling is not required if you only use softened water.
In this case, change the water hardness level to
softened "-".
Changing the water hardness level
Touch and hold ON/OFF until the appliance turns on.
1.
Touch and hold INFO for approximately 4 seconds.
2.
The initial basic setting
Touch INFO repeatedly until
3.
level) appears in the display.
Use the settings dial to change the water hardness
4.
level.
Options:
- softened
1-soft
‚
2-average
ƒ
3-hard
„
4-very hard
...
Touch and hold INFO for approximately 4 seconds.
5.
The change is stored.
Cleaning
Before initial use, heat up the appliance once while
empty and clean the accessories.
Heating up the appliance
Fill and slide in the water tank.
1.
Touch and hold ON/OFF to turn the appliance on.
2.
OVEN MODE lights up on the display.
Use the settings dial to set the oven mode to
3.
Steam .
Á
Touch START/STOP to turn on the appliance.
4.
The appliance automatically heats up to 210 °F
(100° C) and turns off after 20 minutes. A beep
sounds.
Touch and hold ON/OFF until the appliance turns off.
5.
Leave the door open a crack until the appliance has
cooled.
Cleaning accessories before use
Clean the accessories thoroughly with soapy water and a
cloth before initial use.
appears in the display.
'‹‚
(water hardness
'‹ˆ
I
II
III
IV

Fill water tank

When you open the door, you'll see the water tank to the
right.
NOTICE: Use of inappropriate liquids can damage the
appliance!
Only use fresh tap water, softened water, or mineral
▯
water without carbonation.
If your tap water contains a lot of lime, we recommend
▯
softened water.
Do not use distilled water, highly chlorinated tap water
▯
(> 40 mg/l), or any other liquids.
Information about your tap water can be obtained from
your water utility office. The hardness of your water can
be tested with the accompanying test strip.
Fill the water tank before each use:
Open door and remove water tank (picture A).
1.
Fill the water tank to the "max" line with cold water
2.
(picture B).
$
Close tank lid until it snaps.
3.
Insert water tank completely (picture C).
4.
&
The tank must be flush with the tank funnel (picture D).
After each use
Empty the water tank after each use.
Keep the water tank level while slowly pulling it out of
1.
the appliance to ensure that no remaining water drips
down and out through the vent.
Pour out the water.
2.
Thoroughly dry the seal of the tank lid and the slot
3.
where the tank resides in the appliance.
%
P D [
'
13