Operating The Appliance - Thermador MES301HS Use And Care Manual

Indication of water level
The 9 indicator lights up:
The water tank is only half full.
If you think that the amount of water in the water tank is
sufficient for what you want to cook, you can start the
appliance. If the water level is too low, then fill the water
tank up to "max", slide the tank back in and then start the
appliance.
The 9 indicator starts flashing:
The water tank is empty. A beep sound and operation is
stopped.
Carefully open the oven door. Steam will escape from
1.
inside.
Remove the water tank, fill it and slide it back in.
2.
Press START/STOP.
3.
Automatic Calibration
The temperature at which the water will boil depends on
the air pressure. During calibration, the appliance is
adjusted to the pressure conditions in the area where it
has been installed. This takes place automatically the
first time steam is used at 210 °F (100° C). More steam
than usual will be produced during calibration.
After moving: To ensure that the appliance will
automatically adjust to the new location, reset the
appliance to its factory settings (see Basic Settings)

Operating the Appliance

This section covers the following:
Turning the appliance on and off
▯
Important instructions to follow after each use.
▯
WARNING
9
SCALDING HAZARD
Movement when opening the appliance door and
when removing the cookware can cause hot liquid
to spray out. Do not stand too close to the
appliance when opening it. Open appliance door
carefully. Remove cookware carefully. Keep children
away.
Turning on the Appliance
Expample shown in the illustration:
Set the oven mode to Steam at 175 °F (80° C).
Touch and hold ON/OFF until the appliance turns on.
1.
OVEN MODE lights up in the display. The first oven
mode, True Convection
Use the settings dial to set the desired oven mode.
2.
14
è appears in the display.
Touch OVEN TEMP and use the settigns dial to set the
3.
temperature.
Touch TIMER/CLOCK repeatedly until the arrow
4.
appears after the
xO
Use the settings dial to set the Cook Time (see Clock
5.
and Timer Settings).
Press START/STOP to turn on the appliance.
6.
The appliance starts to heat up. When using Steam
mode, the Cook Time starts after the appliance is
preheated.
Changing the temperature
After Cook Time starts, you can turn the settings dial at
any time to change the temperature.
Changing the End Time
See Clock and Timer Settings, Changing the End Time.
Turning Off the Appliance
WARNING
9
RISK OF SEVERE BURNS
Hot steam may escape when opening the appliance
door. Carefully open the door only after cooking is
finished.
At the end of Cook Time
If you set a cook time, the appliance will turn off
automatically. A beep sounds. Press TIMER/CLOCK to
stop the signal.
Touch and hold ON/OFF until the appliance turns off.
Carefully open the appliance door.
Pausing Operation
Touch START/STOP or open the appliance door. The
appliance pauses operation. START/STOP flashes.
Close the appliance door and press START/STOP to
resume operation.
If you have activated Autostart, the appliance will not
resume operation (see Basic Settings).
Canceling Operation
Touch and hold ON/OFF to cancel operation and turn off
the appliance.
The cooling fan may continue to run when you open the
appliance door.
Cook Time symbol.