After Use Care; Cutting System - CanyCom CMX 227 Operator's Manual

After Use Care

Cutting System

• Never place any part of body under cutting blade shield when cutting blade is
rotating.
• Do not allow bystanders to come near machine when cutting blade is rotating.
• Always stay on machine when performing this opeartion
• Never attempt to clean cutting system with cutting blade shield open. Stones or
rocks can be thrown and cause damage to surrounding properties or persons.
• Turn cutting rotary clutch to [ON] only when cleaning. Keep it in [OFF] position
all the other times.
Hose Connection
5335M-0510-010E
6. Move cutting rotary clutch lever to [ON] to rotate cutting blade to clean.
7. When cleaning is done, move cutting rotary clutch lever to [OFF] to stop cutting blade.
8. Move cutting height adjust lever to [150] for CMX227 and CM226, [130] for CMX186 and
CM 185.
9. Turn throttle lever to [
10. Stop machine and remove hose.
NOTE
• Do not set cutting height too low. It may hit ground.
Maintenance
1.
2.
3.
4.
5.
(slow)] to lower engine speed.
-75-
Park machine.
Set cutting height to about 50mm.
Connect hose to hose connection. Run
water through hose.
Start engine.
Turn throttle lever to [
engine speed.
5
(fast)] to raise