After Use Care; Cutting System - CanyCom CMX222 Operator's Manual

5

After Use Care

Cutting System

• Never place any part of body under cutting blade shield when cutting blade is
rotating.
• Do not allow bystanders to come near machine when cutting blade is rotating.
• Always stay on machine when performing this opeartion
• Never attempt to clean cutting system with cutting blade shield open. Stones or
rocks can be thrown and cause damage to surrounding properties or persons.
• Turn cutting rotary clutch to [ON] only when cleaning. Keep it in [OFF] position
all the other times.
5323M-0511-010E
Maintenance
Cap
1. Park machine.
2. Set cutting height to about 50mm.
NOTE
• Do not set cutting height too low It may hit
ground.
3. Remove cap and connect hose. Run water
through hose.
4. Start engine.
5. Turn throttle lever to [
engine speed.
6. Move cutting rotary clutch lever to [ON] to
rotate cutting blade to clean.
7. When cleaning is done, move cutting rotary
clutch lever to [OFF] to stop cutting blade.
-74-
(fast)] to raise