Cutting Rotary Drive Belt And Cutting Rotary Brake - CanyCom CMX 227 Operator's Manual

5

Cutting Rotary Drive Belt and Cutting Rotary Brake

• Never place any part of body under cutting blade shield when cutting blade is
rotating.
• Do not allow bystanders to come near machine when inspecting cutting rotary
brake.
• Ride on machine when testing cutting rotary brake.
• Never attempt to check the performance of cutting rotary brake with cutting
blade shield open. Stones or rocks can be thrown and cause damage to
surrounding properties or persons.
• Inspect cutting rotary brake whenever the performance of it seems inadequate.
• Adjust belt tension properly. Inproperly tensioned belt may reduce performance
and its service life.
• Always adjust cutting rotary brake after adjusting cutting rotary drive belt.
NOTE
• The V-belt stretches (breaks in) when it is new. Inspect and adjust the V-belt after
the first day's (4 hours') use.
• For a longer service life, inspect and adjust (as necessary) the V-belt as the daily
pre-start up checks.
Maintenance
-68-