Table of Contents
Advertisement
Lock Nut
Turnbuckle
5347M-0508-020E
Cutting Rotary Brake
• Never place any part of body under cutting blade shield when cutting blade is
rotating.
• Do not allow bystanders to come near machine when inspecting cutting rotary
brake.
• Ride on machine when testing cutting rotary brake.
• Never attempt to check the performance of cutting rotary brake with cutting
blade shield open. Stones or rocks can be thrown and cause damage to
surrounding properties or persons.
• Inspect cutting rotary brake whenever the performance of it seems inadequate.
• Stop engine when adjusting cutting rotary brake.
Maintenance
5.
If washer is not aligned with the notches,
loosen lock nut and adjust turnbuckle.
6.
Tighten lock nut.
NOTE
• If washer cannot be aligned to the nothces
by adjusting turnbuckle (V-belt tension
cannot be set within the specified range),
V-belt needs to be replaced. Contact your
CANYCOM representative for replacement.
7.
Reinstall lower rear cover, engine hood, and
rear bumper.
-71-
5
Hide quick links:
Advertisement
Table of Contents
