Siemens SCALANCE W788-1PRO Operating Instructions Manual page 244

Configuration Using Web Based Management and the Command Line Interface
Below, yo
the signal
● Use a fixed data rate in the configuration.
● Where possible, the ipcf mode with as low an up
be set for the measurements.
● Make sure that there is enough data communication during the measurement
because the statistics functions evaluate incoming frames.
● The measurement setup should be run through 2-3 times with the same
para meters to find out whether losses of signal strength always occur at the
sam e position.
● Selective measurements at a fixed position should be made over a
time.
Figure 6-3
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
u will find a few tips that will help you to obtain useful measurements with
recorder:
Screen Display of the Measured Values
date time as possible should
certain
244