Siemens SCALANCE W788-1PRO Operating Instructions Manual page 147

Configuration Using Web Based Management and the Command Line Interface
Syntax of the Command Line Interface
CLI\INTERFACES\WLAN1>
or for the second wireless adapter (if it exists)
C LI\INTERFACE S\WLAN2>
Co mmand
port [E|D]
ssid [network name]
mode [A|B|G|H|T|U|X]
autoch [E|D]
channel [1...167]
altchan [channel]
adopt [MAC address]
autoadopt [E|D|OWN|L2T]
adhoc [E|D]
anyssid [E|D]
vapno [0...7]
outdoor [E|D]
802.11 g
ADVANCED
DATARATES
VAP1
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
Description
Enable / dis able wireless port.
Assigns a network name (SSID).
Selects the transmission standard:
A 802.11a
B 802.11b
G 802.11g
H 802.11h
T 802.11a Turbo
U 802.11h Turbo
X 802.11g Turbo
Enable / dis able the channel
selection by the SC ALANCE W78x.
Specifies the wireless channel.
Enters the channel numb
alternative DFS cha nnel.
MAC address of the devic
connected to the client over
Ethernet.
Automatic adoption of the
address of the device co nnected to
the client over Ethe rnet.
The OWN parameter means that the
client registers with the access point
with its own Ethernet MAC address.
With this setting, however, only IP
data traffic is possible.
Select ad hoc or infrastructure
mode.
With ANY SSID, the client connects
to the best access point in the
environment in which it is permitted
to connect.
Specifies the number of virtual
access points
Enable / disable outdoor AP mode
Open the ADVANCED G (802.11g)
menu
Open the ADVANCED menu
Open the DATARATES menu
Open the VAP1 menu
Comment
Available only in the
access point mode.
Depending on the country
code, some settings are
not possible and will then
be rejected.
802.11a Turbo cannot be
set in all countries.
Available only in the
access point mode.
er of the Possible only in 802.
transmission.
e A vailable only in the client
m ode.
MAC A vailable only in the client
m ode.
Available only in the client
mode.
Available only in the client
mode.
Displayed only when
vapno > 0.
11h
147