Siemens SCALANCE W788-1PRO Operating Instructions Manual page 119

Configuration Using Web Based Management and the Command Line Interface
Reaction to System Events
The following alternativ
● The SCALANCE W
● The SCALA
● The SCALANCE W
● The SCALANCE W
By selecting the approp
re actions on the SCALANCE W78x. With
row, you enable
Syntax of the Command Line I
For each of the four po
(Enabled, setting is ena
as the parameter. If, for example, an E-
resta rts (first paramete
trap nor an error is gen
setec CW E D E D
CLI\SYSTEM\EVENT>
Command
setec CW <E|D> <E|D>
<E|D> <E|D>
setec LU <E|D> <E|D>
<E|D> <E|D>
setec LD <E|D> <E|D>
<E|D> <E|D>
setec AF <E|D> <E|D>
<E|D> <E|D>
setec PM <E|D> <E|D>
<E|D> <E|D>
setec PE <E|D> <E|D>
<E|D> <E|D>
setec FC <E|D> <E|D>
<E|D> <E|D>
setec AP <E|D> <E|D>
<E|D> <E|D>
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
es are possible:
78x sends an E-mail.
NCE W 78x triggers an SNMP trap.
78x writes an entry in the log file
78x indicates an erro
riate check boxes
or disa ble the sending of E-mails or tri
nterface
ssible reactions E-mail, tr
bled) or D (Disabled, sett
r "CW") and an entry is made in the
erated, the following comman
Description
Reactions when the
SCALANCE W78x restarts.
Reaction to the Link Down event on
the Ethernet interface.
Reaction to the Link Up event on the
Ethernet interface.
Reaction to a bad authentication
over Web Based Management, CLI,
or SNMP.
Reaction to a change of power
supply over the M12 power
connection.
Reaction to a change of power
supply over Ethernet.
Reaction to a change in the error
status.
Reaction to detection of an access
point on own or an overlapping
wireless channel.
.
r (the error LED lights up).
, you specify which events trigger which
the check bo x in the
gge ring of SNMP traps
ap, log an d fault, e
ing is disa bled) must be entered
mail is se nt when t he SCALANCE W78x
log table but neither a
d mus t be entered:
If the error status was
triggered only due to a
link down event, the error
states is cleared and the
error LED goes off.
The SNMP trap AuthFault
is sent only if there is a
bad SNMP authentication.
This command is not
available in the client
mode.
Functions enable d
.
ither E
Comment
119