Siemens SCALANCE W788-1PRO Operating Instructions Manual page 106

Configuration Using Web Based Management and the Command Line Interface
The HiPath Access Point Mo
Note
The Hi Path Access
model, firmware ver
The HiPath Access
• The SCALA
commu
• After changing t
is no lon
the HiPa
Notice
After changing to the HiPath Acce
default status; in other words, the
If your access point was already configured and you want to use the configuration
later, save it before you change over as described in Section 6.2.11, Load & Save.
Follow the steps outlined below to change the SCALANCE W788-2RR to the
HiPath Access Point mode:
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
de
Point mode is available only with the
sion 2.4 o r higher.
Point mode is intended for the follow
NCE W788-2 RR is an access point in a Siem
nications system.
o the HiPath Access Point mode, the S
ger configured wit h the WBM or the Comma
th Wire less Controller of the communication
ing
ss Point mode, the access point is returned to its
configuration is lost.
SC ALANCE W788- 2RR
situation:
ens WLAN HiPath
CALANCE W788-2RR
nd Line Interfa ce but by
s sy stem.
106