Configuration Using Web Based Management and the Command Line Interface
6.3
Interfaces Menu
Introduction
The SCALANCE W78x has one Ethernet interface and up to two WLAN interfaces
that can be configured separately. In the pages of this menu, you can configure
both the wired Ethernet interface and the WLAN
With the menu command Interfaces > WLAN1...2 > Virtual AP count in the Access
Point m
ode, you can also configure up to eight virtual access points (VAP0 ...
VAP7) per wireles
Note
VAPs are visible only after an AP count > 0.
6.3.1
Ethernet Menu Command
Transmission Speed and Mode
For a wired Ethernet interface, you only to specify the transmission speed / mode
parameters and the crossing over of the E
entry Auto in the Speed / Mode list box, the SCALANCE W78x sets a suitable
speed and mode depending o
Ethernet connection.
If you select an entry other than Auto in the Speed / Mode list box, you must
specify the crossing over of the Ethernet connection manually with Ethernet
crossing.
Note
If you specify the mode, you must make the same sett
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
s interface.
n the other network nodes and crosses over the
interface.
thernet connection. When you select the
ings on the partner device.
141