Connections; Power Connection; Switching On - Barco barcoelm r18 Owner's Manual

4. CONNECTIONS

Overview
•

Power connection

•

Switching on

• Switching to standby
• Switching off
• Input Source Connections
• Communication Connections
4.1 Power connection
AC Power cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the left of the projector. The power input is 230 VAC.
Fuses
For continued protection against fire hazard :
• refer replacement to qualified service personnel.
• ask to replace with the same type of fuse (T7 AH/250V).
4.2 Switching on
How to switch on.
1. Press the power switch to switch on the projector.
- When '0' is visible, the projector is switched off.
- When '1' is visible, the projector is switched on
The projector starts in standby mode. The projector indication lamp is red.
Starting image projection.
1. Press Stand by key once on the local keypad or on the remote control.
The projector mode indication lamp will be green (image 4-1)
Or,
Press a digit button to select an input source.
Image 4-1
Standby indication
R5976333 BARCOELM R18 17092002
Downloaded from ProjectorsManual.com Manuals
4. Connections
25