Table of Contents
Advertisement
Image 3-6
Rotating the Projector 180
3.4 Safety Area around ProjectorSafety Area
Safety area
Make sure the projector is located so that the air inlets and outlets for the cooling system are not obstructed. Leave a safety area A
of about 1 meter on the left and the right side of the projector.
Image 3-7
Safety area around the projector.
3.5 Installation of the Lamp Casing
Never transport the projector with the lamp casing installed. The lamp casing should always been transported
in a vertical way to avoid damaging the lamp.
Never attempt to disassemble the lamp from its housing or to dispose of it other than by returning it to BARCO.
Due to its high internal pressure, the lamp may explode in either hot or cold state.
Installing the projection lamp.
1. Unplug the projector from the wall outlet.
2. On the input side of the projector, remove the side by turning the 4 quarter turn fastener studs a quarter turn counter clockwise.
(image 3-8)
3. Flip the lower side of the plate a little and carefully pull it downwards to remove.
4. Take the lamp casing carefully out of its shipping box.
5. Place the lamp casing on the optical base plate. (image 3-9)
R5976333 BARCOELM R18 17092002
Downloaded from ProjectorsManual.com Manuals
3. Installation Guidelines
15
Advertisement
Table of Contents
