Spare Parts - Stiga garden scoop Instructions For Use Manual

GB
4. Loosen the spring U and remove the tension
roller V (fig 25).
5. Loosen the belt guide X and turn it to the side.
6. Pry-off the old belt over the gearbox pulley.
Work from above the machine and use the hole in
the bottom plate.
7. Pry off the belt from the engine pulley. Bend
down the belt guide S and place the belt in the low-
er groove. Bend up the belt guide and remove the
old belt.
8. Fit a new genuine v-belt in the reverse order.
ADJUSTING THE BLADE BRAKE
1. Set the blade lever in the rear, disengaged posi-
tion.
2. Loosen the blade brake Y and adjust so that it
lies flat against the pulley (fig 26).
3. Tighten the screws and nuts.
Replace the blade brake pad when it has be-come
worn.
BLADE
Make sure the blade is always sharp. This gives the
best mowing results.
SHARPENING
For safety reasons the blade must not be sharpened
on an emery wheel. Incorrect sharpening (= high
temperature) can result in the blade becoming brit-
tle.
When the blade is due to be sharpened, the wet
grinding method with a waterstone or grindstone is
to be used.
Following sharpening, the blade must
be balanced to avoid vibration damage.
CHANGING BLADE
Always use original spare parts when changing the
blade, blade attachment or bolt.
Always use original spare parts. Using
non-original spare parts can result in
the risk of damage even if they fit in the
machine.
When changing the blade, the blade centre bolt
should also be replaced. It is provided with a lock-
ing device. The blade bolt torque: 65 Nm.
50
ENGLISH

SPARE PARTS

STIGA original spare parts and accessories are
constructed exclusively for STIGA machines.
Note that non original spare parts and accessories
have not been checked or approved by STIGA:
Usage of such parts and accessories can
influence the machines operability and
safety. STIGA cannot be held responsi-
ble for injuries caused by these prod-
ucts.
STIGA reserves the right to make changes in the product
without prior notice.