Toro 41235 Operator's Manual page 15

Figure 10
1. Hood
2. Pivot the bottom of the hood upward until the top
mounting tabs can be pulled from the frame slots
(Figure 10).
3. Pivot the top of hood forward and unplug the wire
connectors from the head lights (Figure 10).
4. Remove the hood.
5. Locate the electrical wire harness and fuse block in
loose parts.
6. Remove the screws securing the existing fuse blocks
to the frame. Slide the new fuse block into the open
grooves of the existing blocks.
7. Wire the electrical harness to the fuse block by joining
the wires in the harness to the corresponding wire
connectors in the back of the fuse block (Figure 11).
1. Wire harness
2. New fuse block
3. Yellow wire
4. Orange wire
5. Red wire
6. Pink wire
8. Connect the black ground wire to the existing 1/4 inch
bolt on the interior side of the vehicle frame, using the
star washer (Figure 12).
2
6
7
4
1. Fuse block
2. Screws ( #10-24 x 3/4
inch)
3. Lock nut (#10-24 inch)
4. Black ground wire
9. Locate an open red power wire coming from the
existing fuse block. Connect it to the matching red
power wire coming from the new fuse block.
10. Install the fuse block and harness to the frame along
side the existing fuse blocks, using the two screws
(#10-24 x 3/4 inch) and two locknuts (#10-24) as
shown in Figure 12.
15
Figure 11
7. Black ground wire
8. Foam marker fuse slot
9. Left boom actuator slot
10. Right boom actuator slot
11. Spray system power fuse
slot
3
1
G011747
5
Figure 12
5. Ground block
6. Thermal breaker 30 amp,
boom actuators
7. Fuse 10 amp, spray
system power
8. Fuse decal
8