Installing The Radiator Cover(For Workman ® 3000, 4000 Series Only) - Toro 41235 Operator's Manual

1
3
Figure 17
Left hand side shown
1. Lock nut
2. Bolts
2. Remove the cotter pin securing the lift cylinder to the
bracket and slide the lift cylinder outward to allow for
the installation of the hold down brackets.
3. Install the hold-down brackets using the two bolts and
flange nuts removed previously (Figure 18).
Figure 18
Left hand side shown
1. Lift cylinder bracket
2. Hold-down bracket
4. Repeat steps to install the hold-down bracket on the
opposite side.
2
4
G011748
3. Lift cylinder
4. Cotter pin
3. Bolts
4. Lift cylinder
8
Installing the Radiator Cover
(for Workman
series only)
Parts needed for this procedure:
1 Radiator cover assembly
4 Bolt (1/4 x 3/4 inch)
Procedure
The radiator cover is shipped with an additional panel
installed for air cooled vehicles. If you are installing the cover
onto a liquid cooled vehicle, remove the extra cover.
1. Locate the spray system power connector on the wiring
harness installed previously.
2. Install the radiator cover assembly over the vehicle's
radiator (Figure 19).
Important: Make sure the spray system power
connecter is routed toward the front of the vehicle
and not trapped under the radiator cover assembly.
Left hand side shown
1. Radiator cover assembly
2. Bolt (3/8 x 1 inch)
3. Secure the cover to the frame using four bolts (3/8
x 1 inch).
18
® 3000, 4000
Figure 19
3. Spray system power
connector