Toro 41235 Operator's Manual page 28

Spray Pro™ Monitor
The Spray Pro monitor displays and monitors various system
performance data such as vehicle speed and application rates.
It does not control the application rate.
1. LCD screen
2. Selection dial
3. Total area
4. Speed
5. Units of measure
Monitor Display Selection Dial
Use the dial to set the LCD screen display to the following:
•
Total area
Displays the total acres (US), hectares (SI), or sq feet
(TURF) that you have covered since you last pressed the
Reset calibration button for this setting.
•
Speed
Displays the ground speed in miles per hour (if the Units
of Measure is set to US or TURF) or kilometers per hour
(if the Units of Measure is set to SI).
•
Units of Measure
Displays the current measurement unit selection as
follows:
– US (United States measuring system)
– SI (metric system)
– TURF (as US but the volumes are in US gallons per
1000 sq ft instead of US gallons per acre)
•
Application Rate
6. Application rate
7. Sub Area
8. Distance
9. Sub volume
10. Total volume
The monitor has an LCD screen that displays the data you
select, a selection dial, and 4 buttons for calibrating the
monitor (Figure 38).
Figure 38
11. Reset, calibration button
12. Calibrate, calibration button 17. Width
13. Decrease, calibration
button
14. Increase, calibration button 19. Flowmeter calibration
15. Boom selection
Displays the application rate in US gallons per acre
(US), liters pre hectare (SI), or US gallons per 1000 sq ft
(TURF).
•
Sub Area
Displays the total acres (US), hectares (SI), or sq feet
(TURF) that you have covered since you last pressed the
Reset calibration button for this setting, without affecting
the Total Area display. If you press the Reset calibration
button, the Sub Volume resets.
•
Distance
Displays the distance you have traveled in feet (US and
TURF) or meters (SI) since you last pressed the Reset
calibration button for this setting.
•
Sub Volume
Displays the total volume in US gallons (US and TURF)
or liters (SI) that you have applied since you last pressed
the Reset calibration button for this setting, without
affecting the Total Volume display. If you press the Reset
calibration button, the Sub Area resets.
•
Total Volume
28
16. Select units
18. Speed calibration
20. LED