Installing The Control Box Mount - Toro 41235 Operator's Manual

11. Locate a suitable location near the fuse box to install
the fuse decal. Make sure the surface is clean and dry,
then place the decal
12. Install the fuses and thermal breakers:
A. Install the two 30 amp thermal breakers to the left
and right boom lift fuse slots (Figure 12).
B. Install the 10 amp fuse to the spray system power
fuse slot (Figure 12).
13. Route the wiring harness through the opening in the
floor, under the seat base, and rearward along with the
existing wiring.
14. At the ROPS cover, rear of the seat assembly, route the
wiring harness up from under the seat and above the
frame. Make sure the spray system power connector is
out from underneath the vehicle (Figure 13).
1
G011758
Figure 13
1. ROPS cover
2. Wiring harness
3. Left frame
15. Route the harness along the frame and back to where
the speed sensor is connected to the existing wiring
(Figure 9).
16. Disconnect the speed sensor from the exiting wiring
harness and connect it to the electrical connector on
the spray system wiring harness.
17. Install the Y-shaped jumper harness between the speed
sensor and the existing and spray wiring harnesses.
Connect the speed sensor to both the existing wire
harness and the spray system wire harness (Figure 14).
2
3
5
4
4. Spray system power
connector
5. Wire harness routed back
to speed sensor
G012932
1
1. Connect to speed sensor
2. Connect to existing wiring
harness
18. Use wire ties to secure the harness to the existing
wiring and position it away from any moving parts and
heat sources.
19. To install the hood, complete the following:
A. Connect the lights.
B. Insert the top mounting tabs into the frame slots.
C. Insert the lower mounting tabs into the frame
slots.
D. Ensure that the hood is fully engaged in the top,
sides and bottom grooves.
6
Installing the Control Box
Mount
Parts needed for this procedure:
4 Bolt (1/4 x 3/4 inch)
4 Flange nut (1/4 inch)
1
Control box mount
4 Bolt (5/16 x 1 inch)
4 Lock nut (5/16 inch)
1 Adapter plate
For vehicles with a serial number of
240000001 or higher
On some vehicles the control mount plate is attached to
the dashboard at the same point the hand throttle assembly
16
2
Figure 14
3. Connect to spray system
wiring harness
3