Installing The Attachment Hold-Down Brackets - Toro 41235 Operator's Manual

is mounted. If the hand throttle kit is installed it must be
separated from the dashboard in order to install the control
mount plate. Refer to the Hand Throttle Kit Operator's Manual
for directions in removing and installing the hand throttle
assembly.
Install the control box mount to the Workman dashboard (or
adapter plate) using three bolts (5/16 x 1 inch) and three lock
nuts (5/16 inch) as shown in Figure 15.
Note: Some older Workman machines may use four bolts
and lock nuts.
1. Control box mount
2. Dashboard
For vehicles with a serial number of
239999999 or lower
Installing the Adapter Plate
If you are installing the spray system on a Workman vehicle
with a serial number of 239999999 or lower, you will need to
use the adapter plate, bolts, and nuts included in the loose
parts.
Install the adapter plate to the Workman dashboard using
four bolts (1/4 x 3/4 inch) and four flange nuts (1/4 inch)
as shown in Figure 16
Figure 15
3. Bolt (5/16 x 1 inch)
4. Lock nut (5/16 inch)
1. Adapter plate
2. Bolt (1/4 x 3/4 inch)
3. Flange nut (1/4 inch)
7
Installing the Attachment
Hold-down Brackets
Parts needed for this procedure:
2 Hold-down brackets
Procedure
1. Locate and remove the two rear bolts and flange nuts
on the lift cylinder bracket (Figure 17). Retain the
fasteners for later use.
17
Figure 16
4. Control mount
5. Bolt (5/16 x 1 inch)
6. Lock nut (5/16 inch)