Installing The Control Box - Toro 41235 Operator's Manual

10. Check the alignment of the tank skid and the vehicle
frame. If necessary, loosen the bolts securing the pivot
lug to the tank skid frame slightly (Figure 21). Raise the
tank assembly just enough above the vehicle frame to
be aligned and lowered into proper position. Tighten
the bolts on the pivot lug once the tank skid is aligned
with the vehicle frame.
11. Use the access panels on both sides of the tank skid to
check for pinching of any hoses or wiring (Figure 22).
Figure 22
Right side shown
1. Access panel door
Important: If any hoses or wiring on the tank
skid assembly are being pinched or bent, raise the
assembly up, adjust its positioning, and tie items
back.
12. Repeat on the opposite side.
13. Attach the pump drive:
Figure 23
1. Rubber cowling
2. PTO drive shaft
•
Pull rearward on the rubber cowling of the front of
the PTO drive shaft (Figure 23).
•
Install the drive shaft onto the PTO output shaft
(Figure 23).
Important: Verify the PTO shaft is secured by
making sure the locking balls are seated in the
groove of the output shaft.
2. Interior of the tank skid
3. PTO output shaft
14. Line up the front mounting brackets with the hold
down brackets installed previously.
15. Secure the tank skid assembly to the frame with a bolt
(1/2 x 1-1/2 inches), two washers (1/2 inch), and a
locknut (1/2 inch) as shown in Figure 24.
1. Front mounting bracket
2. Hold-down bracket
3. Bolt (1/2 x 1-1/2 inches)
16. Repeat these steps for the front mounting bracket and
hold-down bracket on the opposite side.
10

Installing the Control Box

Parts needed for this procedure:
1 Knob
3 J-clips
1 Bolt (1/4 x 3/4 inch)
1 Flange nut (1/4 inch)
1 Spray Pro decal, US
1 Spray Pro decal, CE
Procedure
The control box is mounted on the tank skid by a clevis pin,
and hair pin. It is located on the left side toward the back.
1. Remove the clevis pin, and hair pin securing the control
box to the tank skid.
2. Install the control box, with the controls facing the
driver, to the control mount using the clevis pin and
hair pin removed previously.
3. Install the hand knob to stabilize the control box.
Tighten by hand.
20
Figure 24
Left side shown
4. Washer (1/2 inch)
5. Locknut (1/2 inch)