Toro 41235 Operator's Manual page 14

Figure 7
1. Wire harness
2. New fuse block
3. Yellow wire
4. Orange wire
5. Red wire
6. Pink wire
5. Connect the black ground wire to the existing 1/4 inch
bolt on the interior side of the vehicle frame, using the
star washer (Figure 8).
Figure 8
1. Fuse block
2. Screws ( #10-24 x 3/4
inch)
3. Lock washer
4. Lock nut (#10-24 inch)
5. Black ground wire, star
washer and bolt
6. Locate an open red power wire coming from the
existing fuse block. Connect it to the matching red
power wire coming from the new fuse block.
7. Install the fuse block and harness to the frame along
side the existing fuse block, using the two screws
7. Black ground wire
8. Foam marker fuse slot
9. Left boom actuator slot
10. Right boom actuator slot
11. Spray system power fuse
slot
6. Fuse 15 amp, foam marker
(Optional)
7. Thermal breaker 30 amp,
boom actuators
8. Fuse 10 amp, spray
system power
9. Fuse decal
(#10-24 x 3/4 inch) and two locknuts (#10-24) as
shown in Figure 8.
8. Remove any dirt, grease from the existing fuse block
decal and make sure the surface is clean and dry. Place
the decal
9. Install the fuses and thermal breakers:
A. Install the two 30 amp thermal breakers to the left
and right boom lift fuse slots (Figure 8).
B. Install the 10 amp fuse to the spray system power
fuse slot (Figure 8).
10. Route the wiring harness through the opening in the
floor, under the seat base, and rearward along with the
existing wiring.
11. At the ROPS cover, rear of the seat assembly, route the
wiring harness up from under the seat and above the
frame. Make sure the spray system power connector is
out from underneath the vehicle (Figure 9).
1. ROPS cover
2. Wiring harness
3. Left frame
12. Route the harness along the frame and back to the
speed sensor with the existing wiring (Figure 9).
13. Install the electrical connector to speed sensor.
14. Use wire ties to secure the harness to the existing
wiring and position it away from any moving parts and
heat sources.
15. Install the front hood and secure it with the screws
removed previously.
for Workman ®
1. While grasping the hood in the headlight openings, lift
up on the hood to release the lower mounting tabs
from the frame slots (Figure 10).
14
Figure 9
4. Spray system power
connector
5. Wire harness routed back
to speed sensor
HD series