Table of Contents
Advertisement
NITROGEN PRO: 9. Seatpost Installation
5.5 Nm
GREASE
THREADLOCKER
BLUE (n. 242)
1. Peel off the plastic of the double-
sided tape located at the back of the
1.4
GREASE
seat clamp wedge (11).
2. Place the seat clamp wedge (11+12)
GREASE
inside the frame.
3. Insert the seatpost (3) on which
LOCTITE
some carbon fiber assembly gel has
been applied.
1Nm
4. Position the seatpost to the desired
CARBON FIBER
height.
ASSEMBLY
COMPOSITE
5. Apply a drop of blue Threadlocker
(n. 242) on the bolt's thread
6. Tighten the set screw at max. 5.5Nm
while leaving a space between the two
parts allowing them to slide.
32
Hide quick links:
Advertisement
Table of Contents
