Tighten the bridge Install the bottle cage mount Install the stem cap Install the bento box Install the wheels Insert the seatpost and seatpost collar CONTACT My E-119 Tri+ Disc Size: Serial number: Seatpost height: Bridge angle: E-119TRI+DISC: travel guide...
Disassembly and packing Tools Needed & emergency repair Kit Remove the wheels SET OF ALLEN KEYS CARBON PASTE CLEAN RAG MEDIUM-STRENGTH & GREASE THREADLOCKER SET OF TORX KEYS TORQUE WRENCH ISOPROPYL ALCOHOL 1. Remove the front wheel using a 6mm allen key. IMPORTANT: 2.
Disassembly and packing Remove the seatpost collar and seatpost Remove the bento box 1. Remove the rear M4 x 16mm screw. 2. Loosen both M4 x 16mm front screws. 3. Lift the rear of the bento box and slide it toward the rear of the bike to remove the unit.
Démontage et empaquetage Remove the stem cap Remove the bottle cage mount 1. Remove both M3 x 6mm stem cap screws. REGULAR POSITION 2. Lift the rear of the stem cap and pull backward until the front edges are clear of the first spacer.
Disassembly and packing Loosen the bridge Remove the bridge 1. Record your bridge angle. . Angles are laser etched on 1. Tilt the bridge backward to access the front spacer M6 screw. ______ _______ _____ the swivel spacer and beam. 2.
Démontage et empaquetage Remove the handlebar Pack your bike 1. Remove both M6 x 16mm screws from the first spacer. 2. Remove the first spacer. 3. Pack the first spacer and screws in the travel bag. M6 x 16 mm 1.
reassembly Install the handlebars Install the bridge 1. Unpack the bike from the travel bag. 1. Apply grease to the threads of the two spacer screws (SKU: 81532 to 81541). 2. Install the handlebar on the fork. 2. Tilt the bridge forward to install the rear spacer M6 screw. 3.
3 Nm 1 Nm reassembly Tighten the bridge Install the bottle cage mount 35 Nm 9 Nm HT-2 1. Adjust the bridge angle as noted while disassembling. 6 Nm 12 Nm REGULAR POSITION 2. Tighten both M6 x 30mm screws to 9 Nm. 4 Nm M5 x 8mm 2 Nm...
reassembly Install the stem cap Install the bento box 1. Insert the front edges into the first spacer grooves. 1. Slide the bento box onto the frame hole on the top tube. Make sure the frame is between the bento box and the clamp. 2.