Table of Contents
Advertisement
KRYPTON PRO 333A / KRYPTON GF-IST 334A: 4.6. Headset Installation
Steps of assembly
1. Insert the headset plastic sleeve into the top on the headtube. (apply grease)
2. Insert the required headset column, 0, 15 or 30mm, in the headset plastic sleeve. (apply grease)
*** After Step 2., complete the frame cable routing before continuing with Step 3. Refer to section 6. or 7. ***
3. Insert bottom bearing on the fork.
4. Slide the fork in the head tube of the frame.
5. Install top bearing in the headset column. (apply grease)
6. Install conical compressor ring.
7. Install stack compressor.
8. Apply grease on the headset seal to avoid any noise.
9. Install the corresponding headset cap to complete the assembly.
10. Fix the cap with the M4 flat head screw.
0mm
15mm
30mm
Like on almost all Argon 18 bikes you will benefit of the 3D system, on the
Krypton Pro / GF-IST you can benefit of 3 positions: 0mm, 15mm and 30mm.
11
Advertisement
Table of Contents
