Argon 18 MY2016 Nitrogen Pro Assembly Manual page 11

NITROGEN PRO: 4. Stem/Handlebar Installation
40Nm
2. Place the elastic cover on the stem and the
spacer with the Argon 18 logo facing up.
3. Place the handlebar upside down on a clean
rag.
4. With the correct spacer and stem length
using a torque wrench, a ratchet extension,
and a 6mm bit thread the bolt and spacer up
to 40Nm.
5. For easier handling and to prevent damage
to the handlebar we recommend holding it
down firmly while tightening.
IMPORTANT:
If the appropriate torque (40Nm)
is not reached and if Loctite is not
applied the handlebar could loosen.
Argon 18 cannot be held accountable
if this is not measured.
10