Frame Inspection - Argon 18 MY2016 Nitrogen Pro Assembly Manual

NITROGEN PRO: 1. Frame Inspection
BEFORE ASSEMBLING YOUR NEW NITROGEN PRO, MAKE SURE THAT YOU HAVE ALL THE FOLLOWING:
1. Brakes and gears cables and housing set
2: Frameset parts checklist (see p.36)
3: Inspect the frame for cosmetic aspect (scratches, bumps, cracks, paint defect, etc.)
4: For reference, check serial number and write it on p.1
5: All the necessary bolts (refer to Frameset Parts, p.3)
6: For optimal shifting performance, use a dropout alignment gauge to make sure that the drive-side dropout is
straight (p.35)
IMPORTANT:
The following parts are assembled on the frame. When assembling the bike, you will need to adjust these parts according to their torque
specifications.
Parts installed on the frame
1 Front derailleur hanger
2 Rear derailleur hanger
3 Bottle cage
4 Bottom bracket cable guide
Description
Screw (2)
Screw (2)
Screw (4)
Screw
Screw Tork Detail
type Nm
3mm 4Nm Loctite
3mm 4Nm Loctite
4mm 3Nm Grease
5mm 1.5Nm Grease
2