Argon 18 MY2016 Nitrogen Pro Assembly Manual page 27

NITROGEN PRO: 7. Cable Housing Installation
Note:
It's better to install the cable housing
before installing the bottom bracket and
crankset.
Rear derailleur: Pass the cable housing
inside the frame starting at the rear
derailleur hanger until it comes out the
top tube.
Front derailleur: Remove the cable
9
guide (9) under the bottom bracket.
Pass the cable housing inside the
downtube until it comes out the top
tube.
Add a plastic cap at the end of the
housing, pass the rear derailleur cable
inside the housing and fix the cable
guide under the bottom bracket with
the 5mm screw (1.5 Nm).
5mm
For a Di2 configuration, use the bottom
1.5Nm
bracket dedicated cover (10) for
electric shifting.
10
26