Argon 18 MY2016 Nitrogen Pro Assembly Manual page 22

NITROGEN PRO: 6. Rear Brake Installation
6Nm
1. Adjust brake pads according to the
width of your rims:
2. Pass the cable through the cable
guide. Make sure that the length of the
cable housing is sufficient for the guide
to remain horizontal as it can cause
interference with the rear wheel tire.
3. Use the proper brake bad spacers
depending on the width of your wheel
rims.
4. Fix the cable to the caliper with the
6mm screw and tighten it to 6Nm.
21