Installing The Attachment Hold-Down Brackets; Hold-Down Brackets - Toro Multi Pro WM 41240 Operator's Manual

1. Install the console mounting bracket to the Workman
dashboard (or adapter plate) using 3 bolts and 3 flange
nuts as shown in Figure 6.
Note: Some older Workman machines may use 4 bolts
and flange nuts.
1 2
1. Bolt
2. Flange nut
2. Insert the 2 plastic bushings into the mounting bracket
(Figure 6).
5
Installing the Attachment

Hold-down Brackets

Parts needed for this procedure:
2 Hold-down brackets
Procedure
1. Locate and remove the 2 rear bolts and flange nuts on
the lift cylinder bracket (Figure 7).
Note: Retain the fasteners for later use.
G022352
3 4
Figure 6
3. Plastic bushing
4. Console mounting bracket
1
3
1. Locknut
2. Bolts
2. Remove the cotter pin securing the lift cylinder to the
bracket, and slide the lift cylinder outward to allow for
the installation of the hold-down brackets.
3. Install the hold-down brackets using the 2 bolts and
flange nuts removed previously (Figure 8).
1. Lift cylinder bracket
2. Hold-down bracket
4. Install the previously removed cotter pin.
5. Repeat the procedure on the opposite side.
14
2
4
G011748
Figure 7
3. Lift cylinder
4. Cotter pin
Figure 8
3. Bolts
4. Lift cylinder