Toro Multi Pro WM 41240 Operator's Manual page 6

– Do not attempt sharp turns or abrupt maneuvers or
other unsafe driving actions that may cause a loss of
vehicle control.
– Do not pass another vehicle traveling in the same
direction at intersections, blind spots, or at other
dangerous locations.
– When draining, do not let anyone stand behind
vehicle and do not drain liquid on any one's feet.
– Keep all bystanders away. Before backing up, look to
the rear and assure no one is behind. Back up slowly.
– Watch out for traffic when near or crossing roads.
Always yield the right of way to pedestrians and other
vehicles. This vehicle is not designed for use on
streets or highways. Always signal your turns or stop
early enough so other persons know what you plan to
do. Obey all traffic rules and regulations.
– Never operate vehicle in or near an area where there
is dust or fumes in the air which are explosive. The
electrical and exhaust systems of the vehicle can
produce sparks capable of igniting explosive materials.
– If ever unsure about safe operation, stop work and
ask your supervisor.
•
Do not use a cab on a Workman vehicle equipped with
a spray system. The cab is not pressurized and will not
provide adequate ventilation when used with a sprayer.
The cab will also overload the vehicle when the spray
system tank is full.
•
Do not touch engine, transaxle, muffler or muffler
manifold while engine is running or soon after it has
stopped because these areas may be hot enough to cause
burns.
•
If the machine ever vibrates abnormally, stop immediately,
turn engine off, wait for all motion to stop and inspect for
damage. Repair all damage before resuming operation.
•
Before getting off the seat:
– Stop movement of the machine.
– Shut engine off and wait for all movement to stop.
– Set parking brake.
– Remove key from ignition.
Note: Block wheels if machine is on an incline.
•
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
Braking
•
Slow down before you approach an obstacle. This gives
you extra time to stop or turn away. Hitting an obstacle
can damage the vehicle and its contents. More important,
it can injure you and your passenger.
•
Gross Vehicle Weight (GVW) has a major impact on your
ability to stop and/or turn. Heavy loads and attachments
make a vehicle harder to stop or turn. The heavier the
load, the longer it takes to stop.
•
Turf and pavement are slick when they are wet. It can
take 2 to 4 times as long to stop on wet surfaces as on
dry surfaces. If you drive through standing water deep
enough to get the brakes wet, they will not work well until
they are dry. After driving through water, you should test
the brakes to make sure they work properly. If they do
not, drive slowly while putting light pressure on the brake
pedal. This will dry the brakes out.
Operating on Hills and Rough Terrain
Operating the vehicle on a hill may cause tipping or rolling
of the vehicle, or the engine may stall and you could lose
headway on the hill. This could result in personal injury.
•
Do not accelerate quickly or slam on the brakes when
backing down a hill, especially with a load.
•
Never drive across a steep hill; always drive straight up or
down or go around the hill.
•
If the engine stalls or you begin to lose headway while
climbing a hill, gradually apply the brakes and slowly back
straight down the hill.
•
Turning while traveling up or down hills can be
dangerous. If you have to turn while on a hill, do it slowly
and cautiously. Never make sharp or fast turns.
•
Heavy loads affect stability. Reduce the weight of the load
and your speed when operating on hills.
•
Avoid stopping on hills, especially with a load. Stopping
while going down a hill will take longer than stopping
on level ground. If the sprayer must be stopped, avoid
sudden speed changes, which may initiate tipping or
rolling of the sprayer. Do not slam on the brakes
when rolling backward, as this may cause the sprayer to
overturn.
•
Reduce speed and load when operating on rough terrain,
uneven ground, and near curbs, holes, and other sudden
changes in terrain. Loads may shift, causing the sprayer
to become unstable.
Loading
The weight of the cargo can change the Workman center of
gravity and handling. To avoid loss of control and personal
injury, follow these guidelines:
•
Reduce the weight of the load when operating on hills
and rough terrain to avoid tipping or overturning of the
vehicle.
•
Liquid loads can shift. This shifting happens most often
while turning, going up or down hills, suddenly changing
speeds, or while driving over rough surfaces. Shifting
loads can cause the vehicle to tip over.
6